-
We removed a 1975 Norton Engine from this chopper frame. Girder front fork. Very unique, as the handlebars and fork are one piece. Hallcraft front wheel, we have the guts for it brake cam, etc., but the brake shoes are bad. Barnett handle grip for throttle, octagon oil tank, some chrome is rough. Rear wheel has a special hanger with junction box, not sure if it's original to Norton. Frame is set up perfectly for Norton. Side stand sits nice and level. Chrome is not nice on the control brackets. Brand new tire, but something rubbed on it and chewed it up a little. Nice winter project! ($1600.00 or call with needs.) Local pickup O.K. Possible low-cost shipping available between CT and OH Thanksgiving week, upon request. * CHECK OUT OUR VIDEO FOR A CLOSER LOOK! * -
We have removed the motor. Call with needs! 330-335-7365 -
This bike was rescued from the scrap pile. Selling for parts only. No title. 20,444 miles. Motor turns over only 180 degrees--possible bent valve. Throttle is locked up. Seat is in bad shape, as shown. Missing left side cover, Gas tank is missing the key. Motor has been painted, paint is coming off. 6-into-1 header. Head is most likely good, as well as cylinders. Fork tubes are nice, headlight stays and bucket are in solid condition. We are not KZ1300 experts, so we're looking for a new home for this bike. Many hard to find parts. CALL WITH NEEDS. 330-335-7365. PRICED TO SELL! -
VIN# JKAKZBD12CA003038 ENG#: KZT10AE014583 We are selling this bike with title, as-is, or parting out. Motor is stuck. No tank, no side covers, hole in bottom of headers. Seat pan rusty. No broken fins. Could be a good donor. Many good parts here. Coils, electrics, shock boots. Selling as-is or parting out. Good title, frame is straight. -
Parting this bike out. Please call with needs. 330-335-7365
Motor is stuck, missing tank, missing side covers, pipes are rusted through on bottom. Seat pan is rusty with holes. Missing point cover. Missing some airbox parts. No broken fins. Many parts are in common with the 77-78 Kawasaki KZ1000A LTD. Triple clamps would be slightly different offset. Meters, master cylinder and switches aren't too bad. If interested, please call us with needs. 330.335-7365 -
We are parting out a 1980 KZ1000 ST. Front tire looks good, rear wheel is ok. Wiring harness looks pretty good. Call us with your needs.
-
Frame # JKAZNBB14FB502477 Eng # KZT10AE024423 We are parting this bike out. It has a couple of issues; under the head by the cam cover has a small crack, as shown. The carbs are off of a KZ1000 J. Exhaust is different, not stock and has no baffle. Brakes in front not bad; rear brakes are locking up. No broken fins. We will separate. Bike has a title. Due to our Ohio weather, it has not been test ridden. New oil, filter, spark plugs. Will run as shown in video. Charging system does not work. Has a lot of good parts, or you can buy this and fix it up. Please call us if interested. 330-335-7365 -
Bike does run. Seat needs recovered 52,000 miles changed oil, filter and spark plugs. 1000 LTD carbs. No broken fins on cylinder or head. Could be a good motor for another police bike or street bike. Doesn’t smoke, could use some tuning. Tachometer and Speedometer are not working. Runs rough. Transmission is good, has all the gears. Goes into gear nicely, doesn’t seem to smoke. Charging system seems to be over-charging; regulator/rectifier is bad, but it is putting out of the stator, so it probably has a good flywheel. Side covers have tab broken off both right and left. We believe these to be original paint. Gas tank has rust inside. Fairing has the bracket on front and some extra holes where equipment has been mounted. Please give us a call with your needs. View movie for more details. -
FRAME# JKAKZBB14CAO12810 ENG# KZ8T10BE012738 Purchased this basket case GPZ along with a Kawasaki Z1. This came from an estate, and it came in boxes. The frame does not appear to be bent. The originals sticker is on the frame and we have a title with this bike. Crank feels okay, probably should be inspected. 18" rear wheel is complete with rotor and sprocket carrier. Rim is nice and straight, not bent. Rear inner fender is intact, with electrical connections. Side stand, 19" wheel is complete and rim is not bent. Cylinder head no broken fins but incomplete, only one cam cap and no cams. Exhaust studs look nice, fuel injection looks good, combustion chambers look good. Fuel injection unit, air box, (only one air box side over), we think the front sprocket cover is correct, brake parts, extra caliper, tail light, handlebars, (one may be bent), mirror, fuel sending unit, gauge, sprocket, ignition switch with key, clutch push rod (bent). See video for details. Sold as shown. Low cost shipping available. FRAME HAS BEEN SOLD, ALONG WITH SWING ARM -
Frame #GA-296707 Eng# G3E 09975 Frame# Motor # We've had this in storage for at least 25 years. Please see updated photos of what is left over. Must sell as-is. Give us a call if you are interested in anything off this bike or the entire piece. 330-335-7365. *Local pickup or possible low-cost shipping upon request* -
Frame #: H1F-26166 Frame appears to be in good shape, except for water damage on lower right leg as shown on front. Does not appear to be bent. No title. This is an oversized item - countries with postal restrictions, please contact us for a shipping quotes. Local pickup welcome. Possible low-cost shipping available upon request. -
VIN# JS1GV74G 7M2100830 ENG# V718-100878 53819 miles. Will be parting out from the motor to the carbs, wheels, etc. 4 into 1 header looks like it has some bluing. Bike starts and runs as shown. Needs some clean up. Has large front forks, right fork has some leaking. Tires are old. Wheels look good, battery is not good. Motor sounds good, no smoking. We just got this bike started. No warranties. Local pickup OK. Call with needs! See video of bike running, below. -
Please call with needs! Motor SC84E***0632 Frame SC04-2000361 Offering for parts only. Stock airbag, fenders are gooned, tires are rotted out. Kick starter okay, we are getting the points cover and right side cover polished. (not shown in photos). Chain guard pretty good. Intake manifolds are junk, dyna cover has been scratched, seat lock is bad, side covers are okay. Wiring harness must be tested. Seat lock is bad. Still good parts on this bike, and some are interchangeable with the KZ1000. -
Call with needs! 44,670 Miles on the odometer 10 speed, shaft drive. Many parts are not genuine. We purchased this bike because we needed parts off if it for another project. Motor is stuck. Dual-range transmission. Wheels are okay, tank is fair. Has some decent parts on it. One of the fork tubes has been goofed. Exhaust has been repaired. Carbs are not complete, missing the top. Tank needs attention, could be cleaned. Seat is goofed, as shown. Sitting as is, it needs a lot of work. THE TANK HAS BEEN SOLD 10/22 -
Parting out a Suzuki GS1100G which had been wrecked. We have not tested the transmission. Hear it turn over in the video. Dyno cover has been smashed. Head is nice. Some crash marks where the exhaust hit the head. Nothing really bad. WE HAVE NO TITLE. SELLING FOR PARTS ONLY! We have some extras; the seat, rear grab bar, side covers, front brake rotors, rear wheel. As always, possible low-cost shipping upon request. -
No title. 2141 miles. This bike was hit from behind. Missing many parts. Carbs missing many parts. WILL SEPARATE! Possible low cost shipping on request. -
Engine turns over nicely and transmission shifts through all gears. Connecting rod feels good. Crank bearings feel as they should. Shifter shaft has been cut, as shown. Case has been welded around the lower cover mount boss. (See pictures of left side.) Local pickup is encouraged. *Call for shipping quote* -
Front end fork assembly with wheel. We recently purchased a small warehouse of parts. This is in decent shape, front fender has some warping from storage. Front wheel is not bent. Tire looks okay. Not the original tire. Not a lot of miles on the front end. Front brakes are not working. Throttle housing still good. Has throttle lock. Sold as complete setup or will part out. Low cost shipping available upon request. Location: Gravestone Building -
Parting out this bike. Many good parts. No title. Motor is stuck. Exhaust looks good - drilled out baffles. View movie for more details. Call with needs. -
Removed from an 82 Kawasaki KZ1100A. Pair of left and right lowers. Paint is extremely faded. Has scratches and scuffs. May fit other models. SOLD AS SHOWN. LOCAL PICK UP. location: white building -
We have taken many parts from this motorcycle over the years, and it's time to find it a new home! This would be a nice project, or a good parts donor. The frame appears to be straight. Sold as shown in photos. Clear Ohio title. Stock # 2145 See movie link below. If you do not want the whole thing, let us know. We will separate. Give us a call. -
Cases are in good shape except for a crack and missing pin, as shown. We took these off of a 1977 and they have a good VIN. Low cost shipping available. Sold as shown Local pickup is encouraged -
These cases are in nice shape and we do not see any damage. Engine Number: KZT10BE024383 Sold as shown Local Pickup encouraged -
Comes with Clear Title. Front wheel has been sold. LTD wheel shown is just for mobility. Has some damage in back where tail light goes, should be an easy fix. -
Chassis with title. Will sell whole or part it out. Stock# 2961 -
We are parting out this bike. Good brakes Please call or email with your needs. -
Parting out this chassis. Front brake works. Charging system worked when it was running. Call with needs -
1988 Kawasaki Concours is missing the gas tank, seat, bags, and bag mounts. Sold as shown. Willing to separate.- Starter works
- Carbs are available
- Exhaust and wheels look good
- Not sure about the motor but it does turn over
- 67,000 miles
-
Frame # SC049CA207534 Sold with title *Call for shipping quote* -
Very nice, no damage. Black finish. VIN# KZT00JE035978 -
4 cylinder parting out. Motor runs well. 19,484 miles. No broken fins, exhaust has some holes. change spark plugs, oil and filter. Serial # KZ750EE034477. Call for Pricing See a video of this motor running. -
- Missing Windshield
- Dunstall Kit
- From our showroom
- Contact us for details
-
Chassis built in 1977. Unique bike, restored with real attention to detail. New brake lines, shock bolts, sealed battery, solid state regulator rectifier, K&N filters, breather filter. Rebuilt carbs, vapor blasted engine cases, polished covers, replaced bolts and hardware, rebuilt brakes, new starter switch, Bator forks, Mulholland shocks, matched powder coated center and side stand, polished breather, foot peg rubbers, center stand stopper, polished chain guard, refurbished gauges. Some cracking and damage on original tailpiece as shown. See the full restoration story below. Buyer is responsible for arranging shipping. Local Pickup is encouraged.
